NEW!! Trailer Eyes Horse Trailer Wireless Monitoring System allows you to see your horses while your trailering them so you KNOW when they are safe and when they require attention. The most affordable, easiest way to see your horses while you're traveling!

Here is how it works....

To set up the camera in your trailer:

1. Use the clamping base to mount the camera. The clamping base can be clamped on any pole or board which is less than 2-¼ inches thick. Choose the mounting spot and tighten the clip bolt on the clamping base.

2. Loosen the tilt lock knob and adjust the camera; point it in the direction you wish to monitor and tighten the tilt lock knob.

3. Insert a 9V battery. Turn the On/Off switch to the ON setting. The camera is set!

To set up the MONITOR in your pulling vehicles:

1. Mount the gooseneck suction mount to the windshield, dashboard, or window.

2. Attach the monitor to the goose-neck suction mount.

3. Attach the antenna connector to the monitor.

4. Open the truck door and mount the booster antenna (magnet base) on the side of your vehicle. Run the wire between the antenna and the monitor through the truck door and the truck frame, not through the window and door frame.

5. Plug the power jack into the monitor; then plug the 12V car lighter adapter into the lighter jack.

6. Turn the monitor on.

7. Adjust the position of the monitor, the antenna wire, and the power wire to avoid interference with the driver.

Voilà! The object of observation is in your monitor now. We are confident to say you will use it once and you'll want it for every trip!

Though not part of the warranty as a trailer monitoring system, there are plenty of other ways to use the wireless camera system if you're within a certain range and if there is no high tension wire or other interference too! I use it in my horse's stall at a show and monitor him from my trailer's LQ-TOTALLY COOL!